Cut out 3 layers of bubble wrap large enough to hang over the tire and rim. Place these over the face side of the tire and rim.
Tuesday
Subscribe to:
Post Comments (Atom)
Popular Posts
-
Put 2 (that's 2) cardboard round cut-outs on the face side of the wheel and tire over the bubble wrap. Next Step ---> -
Cut out a piece of plastic large enough to cover the tire and rim. Place it over the face side of the rim. Next Step---> -
Cut out 3 layers of bubble wrap large enough to hang over the tire and rim. Place these over the face side of the tire and rim. Nex... -
Cut out a piece of soft foam large enough to cover the tire and rim. This will go on top of the plastic piece. Next Step---> -
Place a cut out carboard round on the back facing side of the tire and wheel. Next: Step 8---> -
Using your tape gun, cover the ends of the shrink wrap. Next: Step 11---> -
Take your roll of skrink wrap and go around the tire and rim many times to apply a think cover. Next: Step 10---> -
Find some large pieces of cardboard. place your tire and rim onto the cardboard and trace a line around the tire. Now cut out your cardboar... -
The Completed wheel and tire after being mummy wrapped. Next: Step 12---> -
Place your tire and rim on level ground with the face side up. Next Step--->
Well i think even a single layer of bubble wrap is enough to deal with the protection of the anything delicate to tough. why do you work on that much bubble warping protection.
ReplyDelete